HP ProLiant DL160 Gen8, Maintenance And Service Manual

Page: 59 / 96

Removal and replacement procedures 59
6.
Install the heatsink:
a.
Using the guide pin on the processor backplate, position the heatsink.
b.
Tighten one pair of diagonally opposite screws halfway, and then tighten the other pair of screws.
c.
Finish the installation by completely tightening the screws in the same sequence.
7.
Install the processor air baffle.
8.
Install the access panel.
9.
Do one of the following:
o
Slide the server into the rack.
o
Install the server into the rack.
10.
Connect each power cord to the server.
11.
Connect each power cord to the power source.
12.
Power up the server.
System board
To remove the component:
1.
Power down the server (on page 27 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Remove the server from the rack (on page 28 ).
4.
Remove the access panel (" Access panel " on page 29 ).
5.
Remove the processor air baffle (" Processor air baffle " on page 30 ).
6.
If installed, remove the FBWC capacitor pack (" Capacitor pack " on page 49 ).
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI riser cage.