HP ProLiant BL460c Gen9, User Manual

Page: 24 / 90

Operations 24
o
Install the direct connect SATA cable (on page 19 ).
9.
Install the access panel (on page 16 ).
10.
Install the server blade (on page 28 ).
11.
Power up the server blade (on page 14 ).
Remove the front panel/drive cage assembly
1.
Power down the server blade (on page 14 ).
2.
Remove the server blade (on page 15 ).
3.
Place the server blade on a flat, level work surface.
4.
Remove the access panel (on page 15 ).
5.
Do one of the following:
o
Remove the storage controller/NVMe pass-through board (on page 22 ).
o
Remove the direct connect SATA cable (on page 19 ).
6.
If installed, remove the internal USB drive. To locate the internal USB connector, see "System board
components (on page
11 )."
7.
Remove all DIMM baffles (" Remove the DIMM baffles " on page 16 ).
CAUTION: Always remove the storage controller/NVMe pass-through board before
removing the front panel/drive cage assembly.
8.
Remove the front panel/drive cage assembly:
a.
Extend the serial label pull tab from the front of the server blade.
b.
Remove the two T-15 screws from the front panel/drive cage assembly.
c.
Remove the component.