Power switch assembly
The power switch assembly is attached to the front of the chassis under the drive cage.
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 17
).
2.
Remove the access panel (
Access panel on page 18
).
3.
Remove the front bezel (
Front bezel on page 18
).
4.
Remove the drive cage (
Drive cage on page 24
).
5.
From inside the chassis, disconnect the cable from the system board connector labeled PB/LED (1).
6.
Press the tab on the left side of the power switch (2).
7.
Pull the power switch out the front of the chassis while threading the cable through the hole in the front
of the chassis (3).
To install the power switch assembly, first insert the cable through the hole from the front of the chassis.
After inserting the cable, place the bottom of the assembly into the slot, and then rotate the top up until it
snaps into place.
Power switch assembly
43
