HP ProCurve Series 2810, Management And Configuration Manual

Page: 125 / 420

Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Telnet
N o t e
If you change the Baud Rate or Flow Control settings for the switch, you
should make the corresponding changes in your console access device. Oth­
erwise, you may lose connectivity between the switch and your terminal
emulator due to differences between the terminal and switch settings for these
two parameters.
Changes to console parameters require that you perform a
write memory
and
then execute
boot
before the new console configuration will take effect. To
enable temporary and non-disruptive changes to the terminal mode without
requiring a reboot, use the
console local terminal
command (see page 7-8).
For example, to use one command to configure the switch with the following:
■
VT100 operation
■ 19,200 baud
■
No flow control
■ 10-minute inactivity time
■
Critical log events
you would use the following command sequence:
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
write memory
and
reload
.
Figure 7-3. Example of Executing the Console Command with Multiple Parameters
7-7