HP ProCurve 8116fl, Installation And Getting Started Manual

Page: 63 / 134

Getting Started With Switch Configuration
Setting Basic System Information
N o t e
4.
5.
The management0 interface is created automatically by the system and is
reserved for the management port on the management module.
From Interface Management mode, enter the following command:
where
<
ipaddr
>
is the IPv4 unicast address and subnet mask you assign
to the switch. You can specify the subnet mask in terms of mask bits.
For example:
You can also specify the subnet mask in terms of mask length.
For example:
Enable the management port, by entering the following command:
Here is an example, showing all of the preceding steps:
Switch 8100fl(config-interface-management)#ip address
<ipaddr>
ip address 10.10.1.45 255.255.248.0
ip address 10.10.1.45/21
Switch 8100fl(config-interface-management)#no shutdown
Switch 8100fl>enable
Switch 8100fl#configure
Switch 8100fl(config)#interface management0
Switch 8100fl(config-interface-management)#ip address
10.10.1.45 255.255.248.0
Switch 8100fl(config-interface-management)#no shutdown
6. From Configuration mode, enter the following commands to enable telnet
on the switch:
Switch 8100fl(config)#ip telnet
Switch 8100fl(config-telnet)#no shutdown
7. Enable a terminal line to the switch by entering:
Switch 8100fl(config)#line vty 0
where 0 represents the vty terminal line connection.
N o t e
The ProCurve Switch 8100fl supports up to 10 vty connections for a maximum
of ten incoming remote connections, plus one console connection.
Get
tin
g S
ta
rte
d
With
S
w
itch
Co
nfi
gurati
o
n
3-3