HP ProCurve 6120G/XG, Configuration Manual

Page: 461 / 662

File Transfers
Copying Software Images
Copying Software Images
Using the CLI commands described in this section, you can copy software
images from the switch to another device using tftp, xmodem, or usb.
N o t e
For details on how switch memory operates, including primary and secondary
flash, refer to Chapter 6, “Switch Memory and Configuration”.
TFTP: Copying a Software Image to a Remote Host
Syntax: copy flash tftp < ip-addr > < filename >
This command copies the primary flash image to a TFTP
server.
For example, to copy the primary flash to a TFTP server having an IP address
of 10.28.227.105:
ProCurve# copy flash tftp 10.28.227.105 z0800.swi
where
z0800.swi
is the filename given to the flash image being copied.
Xmodem: Copying a Software Image from the Switch to a
USB Serial Console Connected PC or UNIX Workstation
To use this method, the switch must be connected via the USB console to a
PC or UNIX workstation.
Syntax: copy flash xmodem < pc | unix >
Uses Xmodem to copy a designated configuration file from the
switch to a PC or Unix workstation.
For example, to copy the primary flash image to a serially connected PC:
1. Execute the following command:
Procurve# copy xmodem flash
Press ‘Enter’ and start XMODEM on your host...
2. After you see the above prompt, press [Enter] .
3. Execute the terminal emulator commands to begin the file transfer.
A-25