HP ProCurve 2510G Series, Manual

Page: 99 / 320

4-25
Authentication
Configuring on the Switch
• If the username/password pair entered at the requesting terminal
does not match a username/password pair previously stored in
the server, access is denied. In this case, the terminal is again
prompted to enter a username and repeat steps 2 through 4. In
the default configuration, the switch allows up to three attempts
to authenticate a login session. If the requesting terminal
exhausts the attempt limit without a successful
authentication, the login session is terminated and the operator
at the requesting terminal must initiate a new session before
trying again.
Local Authentication Process
When the switch is configured to use , it reverts to local authentica-
tion only if one of these two conditions exists:
■ “Local” is the authentication option for the access method being used.
■ is the primary authentication mode for the access method
being used. However, the switch was unable to connect to any
servers (or no servers were configured)
and
Local is the
secondary authentication mode being used.
(For a listing of authentication options, see table 4-2, “Primary/Secondary
Authentication Table for Console and Telnet” on 4-14.)
For local authentication, the switch uses the operator-level and manager-level
username/password set(s) previously configured locally on the switch. (These
are the usernames and passwords you can configure using the CLI password
command, the Web browser interface, or the menu interface—which enables
only local password configuration).
■ If the operator at the requesting terminal correctly enters the user-
name/password pair for either access level, access is granted.
■ If the username/password pair entered at the requesting terminal does
not match either username/password pair previously configured
locally in the switch, access is denied. In this case, the terminal is
again prompted to enter a username/password pair. In the default
configuration, the switch allows up to three attempts. If the requesting
terminal exhausts the attempt limit without a successful authentica-
tion, the login session is terminated and the operator at the requesting
terminal must initiate a new session before trying again.