HP ProCurve 1810G, Management And Configuration Manual

Page: 36 / 80

4-2
Switching Pages
Jumbo Frames
■ Click Apply to save any changes for the current boot session; the changes take effect
immediately. Use the Maintenance > Save Configuratio n page to have the setting remain in effect
after a reboot.
To view a summary of port information, click
Status > Port Summary
in the navigation pane.
Jumbo Frames
Use the Jumbo Frames page to enable the switch to forward jumbo Ethernet frames. The jumbo frames
feature extends the standard Ethernet Maximum Transmission Unit (MTU) from 1518 bytes (1522 bytes
with a VLAN header) to 9216 bytes. If it is enabled, any device connecting to the same broadcast domain
should also support jumbo frames.
This feature is disabled by default.
To access this page, click
Switching > Jumbo Frames
in the navigation pane.
Figure 4-2. Jumbo Frames Page
Table 4-2. Jumbo Frames Fields
■
Click Apply to save any changes for the current boot session; the changes take effect
immediately. Use the Maintenance > Save Configuration page to have the setting remain in effect
after a reboot.
Link Speed Configure the duplex mode and transmission rate for the selected port. (These options may change
depending on the port type.)
•
Auto —The rates and duplex mode will be auto-negotiated.
• 10HDX —10Mbps, half-duplex
• 10FDX —10Mbps, full-duplex
• 100HDX —100Mbps, half-duplex
• 100FDX —100Mbps, full-duplex
• 1000FDX —1000Mbps, full duplex (for fiber ports)
Note: The port's maximum capability is advertised.
Field Description
Field Description
Enable Jumbo Frames Select to enable the switch to forward jumbo frames up to 9216 bytes.