HP ProCurve 1600M, Management And Configuration Manual

Page: 370 / 690

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
IP-ADDR: The user-specified IP address that will be used as
the source IP address in the generated trap.
loopback <0-7> : The IP address configured for the specified
loopback interface will be used as the source IP address in
the generated trap pdu. In the case of multiple addresses, the
lowest alphanumeric address will be used.
N o t e
The
snmp-server response-source
and
snmp-server trap-source
commands
configure the source IP address for IPv4 interfaces only.
The
show snmp-server
command displays the policy configuration:
ProCurve_8212(config)# show snmp-server
SNMP Communities
Community Name MIB View Write Access
---------------- -------- ----------- -
public Manager Unrestricted
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Send Authentication Traps [No] : No
Address | Community Events Sent in Trap
---------------------- ---------------- ------------------
Excluded MIBs
Snmp Response Pdu Source-IP Information
Selection Policy : dstIpOfRequest
Trap Pdu Source-IP Information
Selection Policy : Configured IP
Ip Address : 10.10.10.10
Figure 14-11. An Example of Show SNMP-Server with Response Configuration
14-26