Using HP 3D DriveGuard software
The HP 3D DriveGuard software can be enabled or disabled by an Administrator.
NOTE:
Depending on your user privileges, you may be unable to enable or disable HP 3D
DriveGuard. Privileges for non-Administrator users can be changed by members of an Administrator
group.
To open the software and change settings, follow these steps:
1.
In Mobility Center, click the hard drive icon to open the HP 3D DriveGuard window.
– or –
Select
Start
>
Control Panel
>
Hardware and Sound
>
HP 3D DriveGuard
.
NOTE:
If prompted by User Account Control, click
Yes
.
2.
Click the appropriate button to change settings.
3.
Click
OK
.
Adding or replacing a hard drive
The computer supports two hard drives, located in the hard drive bay on the bottom of the computer.
CAUTION:
To prevent information loss or an unresponsive system:
Shut down the computer before removing a hard drive from the hard drive bay. Do not remove a hard
drive while the computer is on, in the Sleep state, or in Hibernation.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.
Removing or replacing the primary hard drive
To remove or install the primary hard drive, follow these steps:
Removing the hard drive
1.
Save your work and shut down the computer.
2.
Disconnect AC power and external devices connected to the computer.
3.
Remove the battery.
58
Chapter 9 Drives
Summary of Contents for Pavilion dv7-6c00
Page 1: ...User Guide HP Notebook ...
Page 4: ...iv Safety warning notice ...
