HP Pavilion 9900 PC, Manual

Page: 18 / 150

14
hp pavilion home pc
Filename: ma1rwob.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: WASSER Studios. Last Saved By: WASSER, Inc.
Revision #: 88 Page: 14 of 50 Printed: 04/25/01 09:02 AM
9 Insert the new card into the slot and push
straight down. (For full-length cards, slide the
card into the vertical slot as well.) Make sure
the card is properly seated.
10 Push the lever up to close the add-in card
bracket.
11 Tighten the two thumbscrews on the back of
the bracket.
To reassemble the computer:
1 Replace the side panel (see “Closing the
Computer” on page 25).
2 Reconnect the power cord and all other
cables.
3 Reconnect the modem/phone cable.
4 Turn on the computer and all peripherals.
5 Install any software drivers supplied by the
card manufacturer.
What Is Plug and Play?
“Plug and Play” describes the ability to add and
remove add-in cards, memory, and peripherals
without any special procedures such as resetting
jumpers and testing for system conflicts. The
system BIOS (basic input/output system) finds
these components and adds them to the system.
You do not have to run the BIOS setup program.
If the New Card or Device Isn’t
Working
Read through the card manufacturer’s installation
instructions, and recheck all connections,
including those to the card, power supply,
keyboard, and monitor. If the problem still exists,
run the BIOS setup program and load the default
settings, and then save and exit.