HP NetServer AA 6200, Administrator'S Manual

Page: 233 / 272

Endurance Server Maintenance 9-17
Installing a Replacement MIC
Caution: Before proceeding, make sure you are properly grounded using,
for instance, a wrist strap with an attached alligator clip that is
connected to an appropriate ground.
To install a replacement MIC:
Step Action Notes
1 Carefully remove the replacement MIC
from its anti-static packaging.
2 Install the replacement MIC into the
correct slot.
3 Replace the cover.
4 Attach the MIC fiber connections by
clipping them into the cable receptacles. Ensure that local and remote connections are
cabled correctly. For information about cabling
the MICs, refer to
Table 2-1 in Chapter 2 of HP
Netserver AA Solution Installation Guide .
5 Power up the system.
6 Make a flash diskette with which you
will flash the MICs. Prepare this from an Endurance distribution
diskette or a subsequent hotfix if applicable.
Refer to
Making an MTC Diskette in Chapter 7
for detailed information about creating the flash
diskette.
7 Flash the MICs.
Mtcflash - f
results in the correct
configuration. If all flash components are up to
date, MTCFLASH does not reprogram the MIC.
8 Compare the revision levels to other
MICs in your system. Verify that the revision level of the new MIC
matches those of the other three MICS in the
server.
9 On the MIC, make sure that the local
and remote connection fiber status
lights are
green .
If the connection fiber status lights are not
green, correct the condition and continue.
For a description of the status lights, refer to
MIC LEDs in Appendix A .
10 Using Endurance Manager:
• Make sure that any components
affected by this procedure are active
or online . Reenable any faulted or
disabled components ( page 9-31 ).
• Make sure that the system rejoins
the Endurance server.