HP N1200 - StorageWorks Network Storage Router, User'S And Service Manual

Page: 14 / 132

14 Installation, cabling, and setup
Desktop installation
Remove the router from the protective bag. Attach the stick-on feet to the bottom four corners of the router.
Place the router on a flat, level table or desktop making sure the airflow vents are clear of obstructions.
WARNING! Do not place objects on top of the network storage router.
Rack mount installation
IMPORTANT: The size of the router and it’s rail assembly is 1U.
The following items in the N1200-320 4Gb Network Storage Router kit are used to install the router into a
rack:
• Two rack mount assembly rails
• Two rack mount extender brackets
• One bag of mounting hardware to include eight #10-32x 6 Phillips screws, and eight #6-32x 312
Phillips screws
IMPORTANT: You need a #2 Phillips and a #2 flat-head screwdriver for this procedure.
To install the network storage router into a rack, determine where the router will be installed in the rack,
making sure the airflow vents remain clear of obstructions.
Separate the rack mount rails
1. Separate the inner rail from the outer rail by placing a thumb over the circular hole at the front-end of
the inner rail, and extend the inner rail out from the outer rail until it locks into place.
2. Press the spring latch on the back of the inner rails to release the lock.
3. While holding down the spring latch, extend the inner rail until the two rails separate.
4. Repeat this process to separate the other set of rails.
Figure 4 Separate rack mount rails