HP ML350 - ProLiant - G2, Maintenance And Service Manual

Page: 33 / 78

Removal and replacement procedures 33
To replace the component, reverse the removal procedure.
Hot-plug SATA and SAS hard drives
To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1.
Determine the status of the hard drive from the hot-plug hard drive LEDs (" SAS and SATA hard drive
LEDs " on page 68 ).
2.
Back up all server data on the hard drive.
3.
Remove the hard drive.
To replace the component, reverse the removal procedure.
Air baffle
To remove the component:
1.
Power down the server (on page 26 ).
2.
Do one of the following:
•
Unlock and remove the bezel (" Front bezel " on page 27 ).
•
Extend the server from the rack (on page 26 ).
3.
Remove the access panel (" Access panel " on page 29 ).