Rack Expansion Kit 42
7.
Pull the pins on the four hinges of the left rear door on the expansion rack, and then remove the door.
8.
Open the front and rear doors of the MCS 5042 to access the baying bracket holes.
9.
Install the six baying brackets, included in your kit contents, between the MCS 5042 and the expansion
rack. You must install the brackets in the same holes where you removed the side panel brackets.
Use the following guidelines:
o
The top baying brackets must be installed in the holes directly under the top hinge of the rack door.
o
The middle baying brackets must be installed in the middle holes of the rack frame.
o
The bottom baying brackets must be installed in the holes directly above the bottom hinge of the rack
door.
To install the brackets:
a.
From the rear of the MCS 5042 and the expansion rack:
i.
Loosely install the three baying brackets to the MCS 5042, inserting one T-30 screw in each
bracket.
ii.
Align the expansion rack with the remaining bracket holes.
iii.
Insert three T-30 screws into the remaining holes, through the baying brackets, and into the
expansion rack frame.
iv.
Using a T-30 Torx screwdriver, tighten all six screws until the baying brackets are secure.
