112
6 Tests and Error Messages
MaxiLife Test Sequence and Error Messages
Basic Pre-boot Diagnostics
The first diagnostic (called basic pre-boot diagnostics) is run to check the
presence of the processor(s) or terminators, power supply, CPU Board PLL
and memory. Simply by having a power cord connected to the PC
Workstation activates the Basic Pre-boot Diagnostics.
The pre-boot diagnostic tests are run in order of priority with respect to
their importance to computer functions.
On the
HP Kayak XM 600 Minitower PC Workstation
, the first detected
error displays a message on the LCD status panel. If this happens, one of the
following screens could appear.
The following diagram shows how the Pre-boot Diagnostics works when it
encounters an error.
Missing or incorrectly
installed processor or
processor terminator
Presence of processor, or
processor terminator
Control of Some Voltages:
12V, 3.3V, 1.8V, 2.5V
If a CPU Power Supply error is displayed, a cause could be with
the power supply cabling or circuits.
System Board is not connected, or
the system board needs replacing.
Control of the CPU Board
ERROR
POWER SUPPLY
ERROR
CPU SOCKET
BOARD PLL
ERROR
MaxiLife Firmware
LCD Status Panel
I
2
C Bus
Voltage CPU1, CPU2
Voltage 12V, 3.3V, 1.8V, 2.5V
CPU or Terminator
PLL Frequency
Vcc State (5V)
An error has been detected when checking the
processor and processor terminator. The
displayed error message could indicate a missing
processor or processor terminator.
System
Memory
ERROR
CPU SOCKET
