HP Integrity rx7640, Installation Manual

Page: 87 / 101

Chapter 2
Installing the Server
Cabling and Power Up
87
The screen displays the default values and asks if you want to modify them. Write down the
information or log it in a file, as it may be required for future troubleshooting. See Figure 2-31.
Figure 2-31 The lc Command Screen
NOTE The value in the IP address field has been set at the factory. Obtain the LAN IP address from the
customer.
Step 3. At the prompt,
Do you want to modify the configuration for the MP LAN?,
enter Y.
The current IP address is shown; and the following prompt displays:
Do you want to modify it?
(Y/[N])
Step 4. Enter Y.
Step 5. Enter the new IP address.
The customer must provide this address for network interface 0.
Step 6. Confirm the new address.
Step 7. Enter the MP Hostname.
This is the host name for the customer LAN. The name can be as many as 64 characters in length,
and include alphanumeric characters, - (dash), _ (under bar),. (period), or a space. HP recommends
that the name be a derivative of the complex name. For example,
Acme.com_MP.
Step 8. Enter the LAN parameters for the Subnet mask and Gateway address fields.
This information must come from the customer.
When this step is completed, the system will indicate that the parameters have been updated and
return to the MP Command Menu prompt (
MP:CM>
)
Step 9. To check the LAN parameters and status, enter the
ls
command at the MP Command Menu
prompt (
MP:CM>
).
MP:CM> lc
This command modifies the LAN parameters.
Current configuration of MP customer LAN interface
MAC address : 00:12:79:b4:03:1c
IP address : 15.11.134.222 0x0f0b86de
Hostname : metro-s
Subnet mask : 255.255.248.0 0xfffff800
Gateway : 15.11.128.1 0x0f0b8001
Status : UP and RUNNING
Link : Connected 100Mb Half Duplex
Do you want to modify the configuration for the MP LAN? (Y/[N]) q