Restoring default settings in Setup Utility
The following procedure explains how to restore Setup Utility default settings. If Setup Utility is not
already running, begin at step 1. If Setup Utility is already running, begin at step 2.
1.
Open Setup Utility by turning on or restarting the computer. When the Press the ESC key for
Startup Menu message displays in the lower-left corner of the screen, press the
f10
key.
– or –
Open Setup Utility by turning on or restarting the computer. When the Press the ESC key for
Startup Menu message displays in the lower-left corner of the screen, press the
esc
key. When
the Startup Menu displays, press the
f10
key.
2.
Use the arrow keys to select
Exit
>
Load Setup Defaults
, and then press the
enter
key.
3.
When the Setup Confirmation appears, press the
enter
key.
4.
To save your change and exit Setup Utility, use the arrow keys to select
Exit
>
Exit Saving
Changes
, and then press the
enter
key.
Setup Utility default settings go into effect when the computer restarts.
NOTE:
Password, security, and language settings are not changed when you restore the factory
default settings.
Computer Setup in Windows 7
85
Summary of Contents for G62 Series
