FRAM71B
User’s Manual
FRAM71B 1.00
- 31 -
©Hans Brueggemann, 2016
The following picture shows a fully assembled programming cable to connect the Flash-
Pro4/5 to FRAM71B:
Picture 14: Assembled programming cable with single red wire "pigtail” to be connected to
CN3:1. Note that the wire is soldered to two pins on the CN5 side, namely pins 3 and 5.
Checkerboard pattern in background is 10 x 10 mm (0.4” x 0.4”). FRAM71B requires connect-
or pin at end of red cable.
On the CN5-side of the cable, a 4 x 2 pin long male header is inserted into the cable’s socket.
A red wire with a single pole connector is connected to pins 3 and 5.
Note brown cross-connection cable on programmer side, which connects pins 2 and 10.
Color sequence on left connector from top to bottom is yellow(1), brown(2), gray(3),
white(4, dummy, no connection, fillet only), red(5), green(6), orange(7), violet(8), blue(9),
and brown (10) again. Pin numbers in brackets refer to 10-pin programming header on
FlashPro4/5.
Color sequence on right connector from top to bottom is gray(8), violet(7), blue(6), green(5),
yellow(4), orange(3), red(2), brown(1). Pin numbers refer to CN5 on FRAM71B, see chap-
ter for reference. Keep length of cable shorter than 80 mm (3 inches).
Picture 15: FRAM71B JTAG Interface pinout and signal naming on CN5
FRAM71:
FRAM71B:
