TV tuner setup
Hardware Setup
3–9
2. Connect the infrared (IR) emitter cable from the IR receiver
to the set-top box.
If you did not include a set-top box in your setup, proceed to
“
Step 4: Complete the setup
,” later in this chapter.
a. Connect the IR emitter cable plug to the connector on the
remote sensor
1
.
✎
Be sure that you connect the IR emitter cable plug to the
connector marked with a “1” on the remote sensor.
b. Remove the backing paper from the IR emitter to expose
the adhesive tape
2
.
c. Press the adhesive side of the IR emitter onto the infrared
(IR) lens on the front of the set-top box
3
.
✎
To help locate the IR lens, shine a flashlight on the front
of the set-top box. The IR lens is usually a small, dark
red window.
✎
If you cannot place the emitter directly over the IR lens,
place it as close to the IR lens as possible.