Flush Glass display assembly
1.
If it is necessary to replace the Flush Glass display enclosure or any of the replaceable Flush Glass
display assembly components, remove the following screw covers
(1)
and screws
(2)
:
2.
Turn the display assembly over.
3.
Slide the display enclosure toward the bottom edge of the assembly
(1)
, and lift up to detach
(2)
.
4.
Disconnect the LED board from the enclosure
(3)
to remove the enclosure.
5.
If it is necessary to replace the camera/microphone assembly, remove the two Phillips PM2.5×4.0
screws
(1)
that secure the camera/microphone module.
6.
Lift the module out as far as the camera/microphone module cable allows
(2)
.
Component replacement procedures
91
