S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
34
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.2(1)
OL-25090-01
Caveats
The following error can be seen in the error-history file for the acltcam process:
switch#
att mod x
switch#
show process acltcam internal errors
...
128) Event:E_DEBUG, length:91, at 553029 usecs after Fri Jan 21 20:41:27 2011
[107] acl_tcam_local_domain_list_init (3331):Unable to get local domains for
existing vsans
...
Workaround
: This issue is resolved.
•
CSCtn01631
Symptom
: The Call Home process crashes and restarts when many RMON hc alerts are sent to Call
Home.
Workaround
: This issue is resolved.
•
CSCtn88331
Symptom
: When you configure an FL port at any speed on a Generation 3 module, the speed is set
by default to 2 Gbps. For example, if you configure the speed to be 8 Gbps, the actual speed on the
hardware is set to 2 Gbps. This issue only occurs when an FL device is attached to a Generation 3
module.
Workaround
: This issue is resolved.
•
CSCtq60165
Symptom
: The IPS module fails and then reloads when FTA is enabled on the FCIP link for the
Read Acceleration feature. This issue occurs when the software is in recovery mode and there appear
to be packet drops on the FICON interfaces.
Workaround
: This issue is resolved.
•
CSCtd04154
Symptom
: The DMM CPP interface cpp1/1/1 does not come up unless there is an active port in
VSAN 1, which is the DMM Management VSAN. There is no interface defined or up in VSAN 1.
Workaround
: This issue is resolved.
•
CSCte70856
Symptom
: The Cisco Call Home feature stops sending Call Home alerts. In some situations, the Call
Home feature might not be able to be configured or displayed. In addition, it might not be possible
to save the configuration. The following syslog messages are logged:
%KERN-2-SYSTEM_MSG: mts_print_longest_queue_state: opcode counts for first and last
50 messages in pers_q of sap 66: - kernela
%KERN-2-SYSTEM_MSG: mts_print_msg_opcode_in_queue: opcode 4853 - 100 messages -
kernel
%KERN-2-SYSTEM_MSG: mts_acquire_q_space() failing - no space in dst sap 66, uuid
63, src sap 28, opcode 4853 - kernel
This issue might be seen when the message level configured in Call Home is higher than that of the
incoming alerts, such as from the RMON alerts from the port monitor feature.
Workaround
: This issue is resolved.
•
CSCtl53991
