HP cc2300, Product Manual, Page: 97 / 135

cc2300 Carrier Grade Server Product Guide 97
For those server applications that require a DB9 type serial connector, the 8-pin
RJ45-to-DB9 (A6900-63003) adapter included in the accessories kit, must be used.
NOTES
1. The RJ45-to-DB9 adapter should match the configuration of the serial
device used. One of two pinouts configurations are used depending on
whether the serial device requires a DSR or DCD signal. The final adapter
configuration should also match the desired pinout of the RJ45 connector,
as it can also be configured to support either DSR or DCD.
2. For systems configured with both a front and rear RJ45 serial connectors,
the adapters used for the rear port cannot be used with the front port, as
the pin-out for both RJ45 ports are different.
Configuration Jumpers
This section describes the jumper blocks that control various configuration options. Figure 32
shows the names and location of the configuration jumpers. The shaded areas show the default
jumper placement for each configurable option. Table 18 describes the system recovery and update
jumper options.
OM12837
DSR DCD
J6A2
BMC
WP
RCVRY
BOOT
PSWD
CLR
CMOS
CLR
D
C
B
A
J1E1
DSR to Pin #7
DCD to Pin #7
Figure 32. Jumper Locations (J1E1 and J6A2)