HP C8088B, Service Manual

Page: 223 / 300

ENWW Chapter 7 Troubleshooting 221
66.12.40
Output device
failure 66.12.40 66.12.40 66.12.40 Amber solid Red (5 blinks) The offset module does not
reach the offset position.
Either the offset module or
the controller circuitry of the
module is damaged.
Recommended action:
NOTE: The device is operable under this condition. However, the device might offset poorly or fail to offset
1 Analyze the event log for frequency of the error message.
2 Turn the printer or MFP off and then on again to see whether the error is present during the power-on
sequence.
3 Replace the offset module as needed.
NOTE: When more than five errors in a row of this type are logged, it is an indication that the offset module has
failed.
4 Replace the controller PCA as needed.
66.12.70
Output device
failure 66.12.70 66.12.70 66.12.70 Amber solid Red (7 blinks) An EEPROM error exists.
One or more cells in the
internal EEPROM on the
controller PCA is damaged.
Recommended action:
NOTE: The device might be operable under this condition. However, because failure of EEPROM affects the
offset feature, the device might offset poorly or fail to offset.
1 Analyze the event log for frequency of the error message.
2 Turn the printer or MFP off and then on again to see whether the error is present during the power-on
sequence.
3 Check the Jet-Link cable connections.
4 If the message persists, then replace the controller PCA.
External device
initializing None None None Amber
blinking Red solid The device is performing its
power-on sequence along
with the printer or MFP.
Recommended action:
This message should appear for a few minutes, if the message persists, then check the following:
1 Make sure that the power cord is well connected.
2 Check connections at the controller PCA.
3 Replace the Jet-Link cable as needed.
4 Replace the controller PCA as needed.
Optional bin 1 full None None None Amber
blinking Green solid The face-up bin is full. More
than 125 sheets of 75-g/m
2
(20-lb) media has been
collected (or fewer than 125
sheets, if heavier media is in
use).
Recommended action:
1 Remove all media from the face up bin.
2 If the message persists when the bin is empty, then make sure that the FLFUF actuator (see page 83)
moves freely.
3 Check the functionality of the FLFUF sensor by using the sensor test (see “Face-up bin-full sensor test” on
page 240).
4 If the FLFUF actuator moves freely and the FLFUF sensor operates correctly, but the message persists,
then replace the flipper assembly.
Table 29. Control panel and event log messages—3,000-sheet stacker (continued)
Control panel
message
Event log, if connected to
User LED Service LED Description 9000 9000mfp
9500, 9500mfp, 9050,
9050/9040mfp