HP C7745NB - SureStore DLT Tape Autoloader 1/9, Service Manual

Page: 30 / 153

30 Connecting and Powering on the Autoloader Chapter 1
Caution To disconnect all power from the autoloader, pull the power cord
from the outlet.
9. Go to the front of the autoloader, and power it on by pressing the power
(standby) switch in the top right corner. After the power-up test completes,
you will see the default Home screen on the front panel display (see Front
Panel Overview on page 36 for more information).
10. Set the SCSI IDs for the autoloader and drive if there will be a conflict with
the default SCSI IDs (see Setting SCSI IDs on page 62 for more
information).
11. Power on other peripherals and then the host.
Figure 9 Autoloader SCSI Cabling Connections
1 Terminator
2 Category 5 Ethernet cable (if RMC is installed)
3 SCSI jumper cable
4 SCSI interface cable to host