HP C7745NB - SureStore DLT Tape Autoloader 1/9, Service Manual

Page: 22 / 153

22 Installing the Autoloader into a Rack Chapter 1
Rackmounting the Autoloader
Remember to:
■
Remove the cosmetic enclosure and feet if you are installing a standalone
autoloader into a rack (see Installing a Standalone Autoloader in a Rack
on page 20 ).
Rackmounting Overview
Here is an overview of the rackmounting procedures that are described on the
following pages.
WARNING Before you begin, lower the rack’s leveler feet, and extend the
rack’s anti-tip device. Failure to extend the anti-tip device could
result in personal injury or damage to the tape autoloader if the
rack tips over.
Install tray
Tighten screws on
front of tray to
secure tray to rack.
Tighten screws on
inside edge of
mounting rails to
secure in place
Install spacer
bracket on front rack
columns
Install trim
bracket and filler panel
Install clip nuts onto
front and back rail
Secure hold-down
bar onto
mounting rail
Install mounting rails
onto rack columns
Install autoloader onto
tray