Connecting to the Command Line Interface
Make an Ethernet cornnection and log into the 4Gb SAN Switch:
1.
Connect the workstation to the Ethernet network containing the OA. If the OA is not
on a network, connect directly to the OA/iLO Ethernet port on the active OA.
IMPORTANT:
Verify that the switch is not being re-con
fi
gured from any other connections during
the remaining steps.
2.
Open a telnet connection using the IP address set earlier. The login prompt displays
when the telnet connection locates the switch in the network.
3.
Enter the user name, using the administrative account
admin
.
4.
Enter the password. The default password is
password
.
NOTE:
Run up to two simultaneous
admin
sessions and four
user
sessions.
If you have not changed the system passwords from the default, you are prompted
to change them. Enter the new system passwords, or press
Ctrl-c
to skip the
password prompts.
5.
Verify that the login was successful. If successful, the prompt displays the switch
name and user ID to which you are connected.
32
Setup
