7.
Screw the hexagonal washer onto the shaft of the screw until it passes all the threads and is secure
within the thumbscrew housing (3).
8.
Repeat steps 1 through 7 for the other thumbscrew.
WARNING!
Remove the two hot-plug power supplies before installing the enclosure into the rack
to reduce weight.
WARNING!
At least two people must lift the enclosure into the rack together. If the enclosure is
loaded into the rack above chest level, a third person must assist with aligning the enclosure with
the rails while the other two people support the weight of the enclosure.
CAUTION:
Do not remove the enclosure from the rack by the thumbscrews. Use the handles
located above the thumbscrews.
To load the enclosure into the rack:
1.
Refer to the
Measuring with the Rack Template on page 17
section in this chapter.
2.
Stand at the front of the rack.
3.
Align the bottom of the enclosure with the top of the rack rails.
4.
Slide the enclosure fully into the rack (1).
22
Chapter 4 Installing and Cabling the HP PC BladeSystem PC Blade Enclosure
ENWW
