HP apollo 4510 gen9, Setup And Installation Manual

Page: 37 / 68

Cabling and powering up the chassis 37
Cabling and powering up the chassis
Cabling the chassis
After all system hardware is installed, cable the components.
WARNING: To reduce the risk of electric shock or injury due to high-current electrical energy,
be sure that all power is completely disconnected at the source before beginning any power
connections to the power bus bars or power bus box.
WARNING: Be sure that all circuit breakers are locked in the off position before connecting
any power components.
CAUTION:
To avoid damaging the fiber cables, do not drape cables from one side of the rack
to the other and do not run cables over a hard corner or edge.
To cable the system:
1.
Connect the network cables to the Ethernet ports on the I/O module (" I/O module components " on
page 14 ).
2.
Connect a network cable to the iLO connector on the management module (" Management module
components " on page 13 ).
3.
Connect the APM cable to the APM connector on the management module (" Management module
components " on page 13 ).
Installing the cable management arm
IMPORTANT: If you need to hinge the cable management arm on the rear right-hand side of
the rack, see the instructions in "Converting the cable management arm for opposite side
mounting (on page 39 )." Perform these steps to convert the arm to a right-hand swing and
install the arm on the right side of the rack.