HP AD560-96002, User Manual, Page: 44 / 136

44 Installing the Library
CAUTION: To avoid damaging the FC cable, do not pinch or sharply bend the cable tighter than a
2-inch diameter. Allow a radial bend when attaching the FC cable to the cable clip.
4. Plug an FC cable (not supplied) into the FC 0 port on the interface controller and plug the other end
into either the host bus adapter (HBA) port on a host or into an FC switch that is connected to the host.
Attach labels to each end of the cable.
5. If a second host is available, plug an FC cable (not supplied) into the FC 1 port on the interface
controller and plug the other end into the HBA port on the host or into an FC switch. Attach labels to
each end of the cable.
6. Plug the Ethernet cable (included in kit) into the Ethernet port on the interface controller and plug the
other end into one of the TO FIBRE CHANNEL CONTROLLERS ports on the Interface Manager card.
Attach a label to each end of the Ethernet cable to mark the port designations.
CAUTION: Use the Ethernet cables provided with the interface controller card kit. Damage to cards can
result from cables that are unshielded.
Cabling the Interface Manager card
Ethernet connections to the Interface Manager card from the e2400-FC 2G interface controllers were
made in ” Cabling the HP StorageWorks e2400-FC 2G interface controllers ” on page 43. To complete
cabling for the Interface Manager card:
1. Plug one end of an Ethernet cable into the CASCADE port of the Interface Manager card and plug the
other end into the PUBLIC port on the library robotics controller.
2. Plug one end of an Ethernet cable into the NETWORK port of the Interface Manager card and plug
the other end into the Ethernet port of your management station.
CAUTION: If the library is prewired with an Ethernet adapter, plug into the adapter, and not a card.
Damage can result to cards by not using the adapter.
3. Label each end of the Ethernet cables with the port designations.
Connecting the power cables
1. Plug a power supply cord into each primary power supply on the base module and tape drive
expansion modules, and plug the other end into a PDU power strip. If a second PDU and redundant
power supplies are installed, plug the power supply cord of each module into separate PDU sources.
For example, plug the power cord of the primary power supply in the base module into a power strip
from PDU 1, and plug the redundant power supply cord in the base module into a power strip from
PDU 2.
2. Plug a power cord into each receptacle on the card cage expansion unit and plug the other ends into
a PDU power strip. If a second PDU is installed, plug each cord into a power strip from separate PDUs
for AC redundancy.
3. Plug each PDU power cord (if more than one) into separate AC power circuits to establish AC
redundancy.