5
Preparing for installation
Safety recommendations
To avoid possible bodily injury and equipment damage, read all safety recommendations carefully
before installation. Note that the recommendations do not cover every possible hazardous condition.
General safety recommendations
x
Keep the chassis clean and dust-free.
x
Do not place the switch on a moist area, and avoid liquid flowing into the switch.
x
Make sure that the ground is dry and flat and anti-slip measures are in place.
x
Keep the chassis and installation tools away from walk areas.
x
Do not wear loose clothing, jewelry (for example, necklace) or any other things that could get
caught in the chassis when you install and maintain the switch.
Electricity safety
x
Clear the work area of possible electricity hazards, such as ungrounded power extension cables,
missing safety grounds, and wet floors.
x
Locate the emergency power-off switch in the room before installation so you can quickly shut power
off when an electrical accident occurs.
x
Unplug all external cables, including power cords, before moving the chassis.
x
Do not work alone when the switch has power.
x
Never assume that power has been disconnected from a circuit. Always check.
Handling safety
When you move an HP A10500 switch, follow these guidelines:
x
Remove all external cables, including the power cords, before moving the chassis.
x
Moving the chassis requires at least two persons, and you can use a mechanical lift as needed.
x
Lift and put down the chassis slowly and never move suddenly.
CAUTION:
x
When moving the switch, hold the handles on the chassis.
x
Do not hold the handle of the fan tray, power supply, or back cover of the chassis, or the air vents of
chassis. Any attempt to move the switch with these parts may cause equipment damage and even bodily
injury.
ESD prevention
To prevent the electric component from being damaged by electrostatic discharge (ESD), follow these
guidelines: