HP 6400cl, Management Manual, Page: 61 / 664

Static Virtual LANs (VLANs)
Configuring VLANs
Show VLAN lists this
data when GVRP is
enabled and at least
one port on the switch
has dynamically
joined the designated
VLAN.
Figure 2-20. Example of “Show VLAN” for a Specific Dynamic VLAN
Changing the Number of VLANs Allowed on the Switch.
In the default
VLAN configuration, the switch allows a maximum of 8 VLANs. You can
specify any value from 1 to 256.
Syntax:
max-vlans < 1-256 >
Specifies the maximum number of VLANs to allow. (If GVRP
is enabled, this setting includes any dynamic VLANs on the
switch.) As part of implementing a new setting, you must
execute a
write memory
command (to save the new value to the
startup-config file) and then reboot the switch.
Note: If multiple VLANs exist on the switch, you cannot reset
the maximum number of VLANs to a value smaller than the
current number of VLANs.
For example, to reconfigure the switch to allow 10 VLANs:
Note that you can
execute these
three steps at
another time.
Figure 2-21. Example of Command Sequence for Changing the Number of VLANs
Changing the Primary VLAN. In the default VLAN configuration, the port-
based default VLAN ( DEFAULT_VLAN ) is the Primary VLAN. However, you can
reassign the Primary VLAN to any port-based, static VLAN on the switch. (For
2-31