HP 6400cl, Management Manual, Page: 164 / 664

PIM-DM (Dense Mode) on the 5300xl Switches
Messages Related to PIM Operation
Message Meaning
I/F removal with IP
< ip-addr >
on vid
Indicates that a PIM interface (VLAN) has been removed
< vlan-id >
(<
counter
>)
from the router as a result of a primary IP address change
or removal.
MCAST flow
< multicast-address > < source- The indicated multicast flow is not routing. The routing
address >
not rteing (rsc low)
switch is low on memory resources as a result of too many
flows for the number of configured VLANs. Remedies
(<
counter
>)
include one or more of the following:
• Reduce the number of configured VLANs by moving
some VLANs to another router.
• Free up system resources by disabling another feature,
such as one of the spanning-tree protocols or either the
RIP or the OSPF routing protocol. (Unless you are using
static routes, you will need to retain a minimum of one
unicast routing protocol.) Another option that may help
is to reduce the number of configured QoS filters.
• Move some hosts that create multicast demand to
another router.
MCAST MAC add for
< mac-address >
failed
Indicates a hardware problem. Check the cabling and router
(<
counter
>)
ports.
Multicast Hardware Failed to
Indicates a hardware failure that halts hardware
Initialize (<
counter
>)
processing of PIM traffic. The software will continue to
process PIM traffic at a slower rate. Contact your HP
customer care center.
No IP address configured on VID
PIM has detected a VLAN without an IP address. Configure
< vlan-id >
(<
dup-msg-cnt
>)
an IP address on the indicated VLAN.
Pkt dropped from
< ip-address >
,(
< cause >
)
A PIM packet from < ip-address > was dropped due to one
vid
< vlan-id >
(<
counter
>)
of the following causes:
• No PIM interface on the VLAN
• Bad packet length
• Bad IP header length
• Bad IP total length
Pkt rcvd with a cksum error from
A packet having a checksum error was received from < ip­
< ip-addr >
(<
counter
>)
address >. Check the cabling and ports on the local and the
remote routers.
Rcvd incorrect hello from
< ip-addr > Indicates receipt of a malformed hello packet. (That is, the
(<
counter
>)
packet does not match the current specification.) Ensure
that compatible versions of PIM-DM are being used.
Rcvd
< text-str >
pkt with bad len from
A peer router may be sending incorrectly formatted PIM
< ip-addr >
(<
counter
>)
packets.
Rcvd hello from
< ip-address >
on vid
Indicates a misconfiguration where two routers are directly
< vlan-id >
(<
counter
>)
connected with different subnets on the same connected
interface.
5-38