HP 6400cl, Management Manual, Page: 587 / 664

Router Redundancy Using XRRP
Configuring XRRP
N o t e
For every VLAN on which you wish to run XRRP, you must first configure the
VLAN with an IP address.
Enabling and Disabling XRRP
Syntax:
[no] xrrp
Once you have completed the XRRP customization, as described in the
previous section, use the
xrrp
command by itself to enable XRRP opera­
tion on the switch for all VLANs on which XRRP has been configured. Use
the
no xrrp
command to disable all XRRP operation on the switch.
Configuration Rules
■ XRRP can be configured only on statically configured IP VLANs. VLANs
automatically created by GVRP cannot be used.
■ XRRP cannot be configured on the management VLAN or on any VLAN
that gets its IP address through DHCP or Bootp.
■ XRRP must be disabled before the Protection Domain number or the
router number configuration can be changed. Use the
no xrrp
command
to disable XRRP.
■ Dynamic reconfiguration – You should be aware that although XRRP can
be reconfigured while it is running, dynamic configurations can lead to
inconsistency between the two routers while the configuration changes
are in progress. This will potentially result in error log messages until the
configurations are consistent (for example, matched IP addresses for
primary on one side and secondary on the other). To avoid these logs,
disable XRRP while changing its configuration.
Use the
no xrrp
command to disable XRRP.
12-15