Message
Description
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-14 Error messages on page 143
.
PRIMARY FRAME TYPE
Frame type selection.
AUTO SELECT
Automatically sense and limit to the first one detected.
EN_8023
Limit to IPX over IEEE 802.3 frames. All others are counted and discarded.
EN_II
Limit to IPX over Ethernet frames. All others are counted and discarded.
EN_8022
Limit to IPX over IEEE 802.2 with IEEE 802.3 frames. All others are counted
and discarded.
EN_SNAP
Limit to IPX over SNAP with IEEE 802.3 frames. All others are counted and
discarded.
NETWORK
FRAME TYPE
RCVD
Network
column specifies the network number associated with a protocol frame type
used for communication between a server and the HP Jetdirect print server.
UNKNOWN
Determining which network number to use.
Frame Type
column identifies the frame type used with the associated network number:
EN_8023, EN_8022, EN_II, EN_SNAP. Unless a specific frame type is manually set,
the print server automatically determines the protocol frame type by listening to the
network data.
DISABLED
Frame type for that network is manually configured.
RCVD
column displays the packets received for each frame type.
Novell/NetWare parameters
Information in this section of the HP Jetdirect configuration page is described in
Table 8-11 Novell/
NetWare configuration information on page 141
. For error messages, see
Table 8-14 Error messages
on page 143
.
Table 8-11
Novell/NetWare
configuration information
Message
Description
STATUS
Current Novell NetWare configuration status.
READY
Print server is awaiting data.
DISABLED
Manually disabled.
INITIALIZING
Registering the node address or name. Additional status messages might
be displayed.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-14 Error messages on page 143
.
NODE NAME
Queue Server Mode
Print server name, which must match a valid print server on the
appropriate NetWare file server. The default name is NPIXXXXXX, where XXXXXX is
the last six digits of the LAN hardware (MAC) address.
Remote Printer Mode
Network printer name. The default name is NPIXXXXXX.
NETWARE MODE
Mode used by the HP Jetdirect print server.
QUEUE SERVER
Receives data directly from the queue.
REMOTE PRINTER
Print server emulates a Novell NetWare remote printer. (The printer
number normally follows this parameter.)
Table 8-10
IPX/SPX configuration information (continued)
ENWW
HP Jetdirect configuration page 141
Summary of Contents for 630n - JetDirect Gigabit EN Print Server
