HP 240 G6, Maintenance And Service Manual

Page: 51 / 108

Hard drive
Three different SKUs related to storage are offered:
● Hard drive only
● M.2 solid-state drive only
● Hard drive and M.2 solid-state drive
For hard drive only models, install the hard drive into hard drive bay. For solid-state drive only models, install
the solid-state drive into the solid-state drive adapter bracket, and then into the hard drive bay. For hard drive
and solid-state drive models, install the hard drive into the hard drive bay and install the solid-state drive into
the separate solid-state drive connector on the system board. System boards are offered with an additional
M.2 solid-state drive connector for hard drive and solid-state drive models.
NOTE: The hard drive spare part kit does not include the hard drive bracket.
Description Spare part number
Hard drives:
1-TB, 5400-rpm 778192-005
500-GB, 7200-rpm 703267-005
500-GB, 5400-rpm 778186-005
Hard drive bracket 925354-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 30 ).
5. Remove the optical drive (see Optical drive on page 31 ), if installed.
6. Remove the bottom cover (see Bottom cover on page 37 ).
To remove the hard drive:
1. Remove the Phillips PM2.5×3.5 screw (1) that secures the hard drive assembly to the computer.
Component replacement procedures 43