HP Array Configuration Utility 24
The Configuration screen appears.
7.
Configure the controller:
o
To configure manually, see "Performing a Configuration task (on page
42
)."
o
To configure with a wizard, see "Using Wizards (on page
51
)" or "Using Express Configuration
(on page
52
)."
8.
When prompted, save the configuration.
9.
Do one of the following:
o
To configure an additional controller, repeat steps 6 through 8.
o
Click
Exit ACU
.
10.
To operate ACU on this server in Local Application mode, do the following:
a.
Click
Start
, and then select
Programs>HP System Tools>HP Array Configuration Utility>Setup HP
Array Configuration Utility
.
b.
When the Execution Mode screen appears, select
Local Application Mode
.
c.
Reboot the server.
11.
(Optional) To make newly created logical drives available for data storage, use the operating system
disk management tools to create partitions and format the drives.
Configuring a local server using ACU located on a remote
server
1.
On the server where ACU is installed, click
Start,
and then select
Programs>HP System Tools>HP
Array Configuration Utility>Setup HP Array Configuration Utility
.
The Execution Mode screen appears.
o
If Remote Service Mode is selected, continue with step 2.
