En
gin
ee
rin
g G
uid
elin
es
3
Engineering Guidelines
Location Requirements
Howe Rapid Freeze Ice Flakers are designed to
operate in ambient room temperatures
between 50°F (10°C) and 100°F (38°C).
Minimum Ambient
Temperature
Maximum Ambient
Temperature
50°F (10°C)
100°F (38°C)
The Ice Flaker warranty is void if it is installed
in ambient room temperatures below 50°F
(10°C)
.
The Ice Flaker must be located above a sanitary
sewer floor drain hub or trench drain to ensure
proper drainage to the floor.
If installing the Ice Flaker with a Howe Ice Bin,
ensure that the bin is adequately secured to
the floor so as to prevent the assembly from
tipping when empty.
Many designers slope floors to the sanitary
sewer inlets to manage these wet areas.
Electrical Requirements
A dedicated 15 amp, 2 pole, 208-230 volt power
supply from a field furnished and installed
disconnect switch is required for each Ice
Flaker.
Water Supply Requirements
Cold water supply to the Ice Flaker must be
totally separate and unaffected by any local hot
water supply.
This cold water supply must be within the range
of 45°F (7°C) to 90°F (32°C).
Minimum Water
Supply Temp.
Maximum Water
Supply Temp.
45°F (7°C)
90°F (32°C)
The cold water supply pressure must be within
a 20 PSIG (140 kPa) to 60 PSIG (410 kPa) range.
Minimum Water
Pressure
Maximum Water
Pressure
20 PSIG (140 kPa) 60 PSIG (410 kPa)
Straight Reverse Osmosis (RO) treated water
should never be supplied to the Ice Flaker.
THE INFORMATION FOUND IN THIS MANUAL IS INTENDED FOR USE BY INDIVIDUALS POSSESSING
EXPERIENCED BACKGROUNDS IN ELECTRICAL, REFRIGERATION AND MECHANICAL REPAIR AND
MAINTENANCE. ANY ATTEMPT TO REPAIR OR ALTER THIS EQUIPMENT MAY RESULT IN PERSONAL
INJURY OR PROPERTY DAMAGE. THE MANUFACTURER IS NOT RESPONSIBLE FOR THE INTERPRETATION
OF THE INFORMATION CONTAINED HEREIN, NOR HAS THE MANUFACTURER ASSUMED ANY LIABILITY IN
CONNECTION WITH ITS USE.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY LOSS, DAMAGE OR INJURY CAUSED AS A RESULT
OF EITHER (I) ANY REPAIR OR REPLACEMENT TO THE MANUFACTURER’S EQUIPMENT THAT IS DONE BY
A THIRD PARTY NOT PREVIOUSLY APPROVED BY THE MANUFACTURER, OR (II) ANY REPAIR OR SERVICE
WORK PERFORMED ON ANY OF THE MANUFACTURER’S EQUIPMENT WHICH DOES NOT STRICTLY
FOLLOW THE PROCEDURES SET FORTH HEREIN.
THE KIND OF REFRIGERANT EMPLOYED IN THE SYSTEM SHALL COMPLY WITH THE STANDARD
FOR REFRIGERANTS UL 2182.
IMPORTANT
Summary of Contents for HoweIce Rapid Freeze 4000-RL-CO 2DX
