Read all instructions.
Use heat press only for its intended use.
To reduce the risk of electric shock, do not immerse the heat press in water or other liquids.
Never pull cord to disconnect from outlet, instead grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces, allow heat press to cool completely before storing.
Do not operate heat press with a damaged cord, or if the equipment has been dropped or
damaged. To reduce the risk of electric shock, do not disassemble or attempt to repair the heat
press, take it to a qualified service person for examination and repair. Incorrect reassembly or
repair could cause a risk of fire, electric shock, or injury to persons when the equipment is used.
Close supervision is necessary for any heat press being used by or near children. Do not leave
equipment unattended while connected.
Burns can occur when touching hot metal parts.
To reduce the likelihood of circuit overload, do not operate other high voltage equipment on the same
circuit.
If an extension cord is necessary, then a 20 amperage rated cord should be used. Cords rated for
less amperage may overheat, care should be taken to arrange the cord so that it cannot be pulled or
tripped over.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
When using your heat press,
basic precautions should always be followed,
including the following:
Safety Instructions
S A V E T H E S E I N S T R U C T I O N S
