AUTO OPEN SERIES
PAGE 6
Operating Instructions
Connecting the System
CONNECT THE POWER CORD
Connect the power cord into a properly grounded electrical outlet with a sufficient amperage rating.
VOLTAGE
120 Volt - The Auto Open 6x6 Press requires a full 10 amp grounded circuit for 120 volt operation.
240 Volt - The Auto Open 6x6 Press requires a full 10 amp grounded circuit for 240 volt operation.
EXTENSION CORDS
If used, should be as short as possible and not less than 12 gauge.
Heavy duty cords are recommended.
CIRCUITS
that have less than 10 amps or that have other high demand equipment or appliances
(especially more than one heat seal machine) plugged in, should not be used.
NOTE:
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid hazard. Use HSJ type, rated 250 V - 10 AMP for replacement.
CAUTION
Failure to follow these instructions will cause:
1.
Erratic controller functions.
2.
Inaccurate displays and slow heat-up.
3.
The circuit breaker to disengage.
A U T O O P E N 6 x 6 P R E S S
To avoid burns, do not touch the heated platen
during use.
Keep hands clear of the upper platen of the press
during platen lock down as the pressure may
cause injury.
Press should be placed on a sturdy, suitable stand
at least 36”L x 24”W x 29”H.
Work area must be kept clean, tidy and free of
obstructions.
Power supply cord must be disconnected before
cleaning or servicing press.
1.
The Auto Open 6x6 Press Operating Instructions are designed with the user in mind.
Carefully read and follow the step-by-step instructions for best results.
1.1
