A
WARNING
●
All ranges can tip.
●
Injury could result.
. Install the Anti-tip device
packed with the range.
. See the Installation
Instructions.
STABILITY DEVICE INSTALLATION INSTRUCTIONS FOR BRACKET KIT NO. 342473
●
Phil I
screwdriver
●
I
open
adjustable wrench
The
attaches to
to hold either the
right or
leveler. fastening to the
be
that the screws do not penetrate electrical
wiring or plumbing. this
be determined, use
shorter screws that
not penetrate through
bracket came with your range, it is shipped
attached to the lower range
Remove
discard
the shipping screw that holds the bracket and then
the instructions below.
1. Decide whether the bracket will be
on
or
side
range location.
the bracket side the
is adjacent to
cabinet,
the bracket against back
cabinet shown in Figure 1.
there is no adjacent cabinet, determine where
the location of the
side (painted outside
)
be.
the bracket with its outside
against the back
1.
Outside edge of
bracket to be flush
with left or right side
.
or final
of range
‘ \
range
Wall behind
3. Determine whether
will anchor
to
the
or wail.
the bracket securely with
the screws provided. The screws are self-drilling in
wood. plywood, particle and
most
metal framing. If
to masonry you can buy
screws
anchors
stores. Use
a masonry
to drill the required
4.
the wrench,
out the
at
two turns. See the Installation Instructions for
information before positioning
5. Slide the
into
sure the
leveler fully engages the slot in the bracket,
cannot be
far
for
the rear
to enter the bracket,
bracket forward
and attach to the hoot
in the new location,
Wall Plate
Screw must enter wood
or metal
Attachment to wall
Make sure
leveler
slot
30
