CARE AND CLEANING
(continued)
A
WARNING
I
●
All ranges can tip.
●
Injury could result.
Install the Anti-tip device
packed with the range.
. See
the
Installation
Instructions.
STABILITY DEVICE INSTALLATION INSTRUCTIONS FOR
342473
Tools needed:
●
Phillips
screwdriver
●
open
or adjustable wrench
attaches to
or wall hold either the
or
leveler. fastening the floor,
that
screws
not penetrate electrical
wiring or plumbing. this cannel be determined. use
shorter screws that
not penetrate through
the bracket came with your range, it is shipped
attached to the lower range back. Remove and discard
shipping screw
holds the bracket and then
the instructions below.
1. Decide whether the bracket will be installed on the
right or
side the range location.
2.
bracket side the range is adjacent to a
cabinet, place the bracket against back wall and
cabinet shown in Figure 1.
there is no adjacent cabinet, determine where
the location the
side (painted outside
panel) will be.
the bracket with its outside
edge at this location
against the back wall.
See Figure 1.
3. Determine whether you will
bracket to
the
or wall. Fasten the bracket securely with
the screws provided. The screws are
in
wood, plywood, particle
chip board,
most
framing. attaching masonry you can buy
suitable screws and
at hardware stores. Use
a masonry drill to drill
required
4. Using the wrench, back out
levelers at
least two turns. See the Installation Instructions
more level i
information
positioning
5. Slide the range into
Be sure
the rear
leveler fully engages the slot in the bracket,
the range cannot be moved
back
enough
the rear
leveler to enter
bracket,
bracket forward as required
attach to
in the new location.
Attachment to wall
engages slot