Hotpoint K964GP, Use And Care Manual

Page: 28 / 40

I
I
LOWER OVEN
Operating the Lower
(continued)
To Set Your Oven
for Self-Cleaning
Quick Reminder:
1. Prepare oven for cleaning.
2. Close oven door completely.
Touch CLEAN pad.
4. Touch INCREASE or
DECREASE pad until desired
time appears.
5. Touch START pad.
Step 1: Close the oven door
completely.
Step 2: Touch the CLEAN pad.
The lower left display shows either
(the default cleaning time of 3
hours) or the cleaning time you
Step
4: When cleaning is done, the
oven starts cooling down. When it
cools down to 500°F., the LOCKED
light goes out and you can open the
door. Display shows time of-day.
How to Delay Start
of Cleaning
Quick Reminder:
1. Prepare oven cleaning.
2. Close oven door completely.
3. Touch CLEAN pad.
4. Touch INCREASE or
DECREASE pad until desired
clean time appears.
5. Touch STOP TIME pad.
6. Touch INCREASE or
DECREASE pad until desired
Stop Time appears in display.
7. Touch START pad.
clay Start is the oven
used.
to the clean automatically
You can change the cleaning time
to little as 1 ‘/z or as much as 4
hours by pressing INCREASE or
DECREASE pad.
Step 3: Touch START to begin
cleaning immediately. The lower
right display shows calculated stop
time. “LOCKED” flashes in the
display for 15 seconds while door
locks automatically, then it appears
steadily.
Note: You might smell a slight
odor, especially during the first
cleanings. This is normal
during the self-cleaning cycle
and is no cause for alarm.
cancel the Self-Clean
cycle at any time by pressing the
CLEAR/OFF pad. However, you
cannot program any other
functions, such as Bake,
the
oven cools to 500°F.
28
at a later time than the present time
of day. NOTE: Before beginning,
make sure the oven clock shows
the correct time of day.
For example: Let’s say it’s
and you want the oven to begin
self-cleaning at
after you’re
finished in the kitchen. The oven
is just soiled a normal amount so
the
Clean Time of 3 hours
is preferred.
Step 1:
Follow steps under
“Prepare the Oven Before Setting
the Controls” to prepare the oven
for cleaning.
Step
2: Close the oven door.
Step
3: Touch CLEAN pad.
Display shows “START,”
“CLEAN” and a cleaning time of
either 3 hours or the last Clean Time
you used. For this example, use a
normal Clean Time of 3 hours.
Step
4: Touch STOP TIME pad.
Step 5: Use INCREASE and
DECREASE pads to enter desired
Stop Time. (Since you are using a
normal Clean Time of 3 hours, you
may enter any time between 3
hours and hours and 59 minutes
from the current time of day.) The
left display shows Clean
Time and the lower right display
shows Stop Time.
Step 6: Touch START pad. The
lower left display now shows Start
Time and the lower right display
shows Stop Time. “LOCKED”
flashes in the display for 15
seconds while the door locks
automatically, then it appears
steadily. “CLEAN” and time of
also appear in display. The light
will turn off automatically.
If you entered an impossible Stop
Time, such as one that is less than
2 hours from the current time of
day, then “Err, “ “START TIME”
and “STOP TIME”
in display.
To correct, press STOP TIME pad
and enter a new Stop Time.
When cleaning is done, the oven
starts cooling down. When it cools
down to 500°F., the LOCKED
light goes out.
Note: The Lower Oven fan and
the Microwave Oven fan may
operate during self-cleaning.