GB
37
• The inside of the oven should ideally be cleaned after
each use, while it is still lukewarm. Use hot water and
detergent, then rinse well and dry with a soft cloth. Do
not use abrasive products.
• All accessories - with the exception of the sliding racks
- can be washed like everyday crockery, and are even
dishwasher safe.
• We recommend that detergents are not sprayed directly
onto the control panel, but that a sponge is used instead.
!
Never use steam cleaners or pressure cleaners on the
appliance.
Cleaning the oven door
!
The door of LED INSIDE models cannot be removed.
Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with
a soft cloth. Do not use rough abrasive material or sharp
metal scrapers as these could scratch the surface and cause
the glass to crack.
For more thorough cleaning purposes, the oven door may
be removed:
1. Open the oven door fully (see diagram).
2. Use a screwdriver to lift up and turn the small levers
F
located on the two hinges (see diagram).
F
3. Grip the door on the two outer
sides and close it approximately
half way. Pull the door towards you,
lifting it out of its slot (see diagram).
To replace the door, reverse this
sequence.
To remove oven door with soft closing hinges*:
1. Open the door completely.
2. Lift the pull-out hooks located
on the two hinges. If you cannot
lift them manually, use a tool as
a lever.
3. Completely rotate downwards
the pull-out hooks.
4. Holding the door by its two
outer sides, slowly close it but
not completely. Pull the door to
remove it from its seat (see figure).
To re-assemble the door follow the
procedure in reverse order.
5. Rotate the pull-out hooks
upwards until they touch the front
of the oven.
6 . P u s h t h e p u l l - o u t h o o k s
downwards,
making sure they are
steady and do not rotate forward
.
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.
Replacing the light bulb
To replace the oven light
bulb:
1. Remove the glass cover
of the lamp-holder.
2. Remove the light bulb and
replace it with a similar one:
halogen lamp voltage 230 V,
wattage 25 W, cap G 9.
3. Replace the glass cover
(see diagram).
!
Do not touch the light bulb directly with your hands.
!
Do not use the oven lamp as/for ambient lighting.
Glass cover
Lamp
Lamp
Holder
compartment
*
Only available in certain models.
