16 of 24
Service Manual UK
Indesit
Company
English
F. Control Module
1.
Remove the plinth by pulling forward.
2.
Remove the top cover.
3.
Remove the right hand side panel.
4.
Disconnect the wiring, noting connections.
5.
Remove the screws securing the module to the
kickstrip.
NOTE
The control module can be programmed with the
relevant Eeprom file if the module is replaced, the
Eeprom file becomes corrupted or if an update file
becomes available. The programming procedure
can be found in Eeprom Writer Manual 5407177.
G. Front Thermistor
1.
Remove the right hand side panel as in (E), or the front panel as in (D).
2.
Disconnect the thermostat wiring and remove the 2 screws fixing the thermistor to the air duct.
H. Door Switch
1.
Remove the top cover as in (A).
2.
Remove the right hand side panel as in (E).
3.
Disconnect the wiring to the switch.
4.
Depress the 2 plastic locating pips on the door switch (taking care not break lugs) and slide the
switch towards the door seal to disengage from the front panel.
I.
Door Seal
1.
Remove the front panel and air duct as in (D).
2.
Separate the air duct from the front panel.
3.
The door seal can now be removed from the front panel.
4.
Replace in reverse order.
J.
Door
1.
Open the door and remove the 4 screws securing the door assembly to the front panel.
2.
Remove the complete door from the front panel.
3.
Remove 1 screw securing the door latch to the door.
4.
Remove the screw behind the door latch, securing the door handle to the door.
5.
Remove the 6 screws securing the two halves of the door assembly.
6.
The door trims can now be split giving access to the door bowl, handle and door hinges.
K. Door Hinges
1.
The door must be removed and split as in as (J1) to (6) above.
2.
Turn the door hinges inwards and slide the hinge to disengage from the rear trim moulding.
Module sits on the base of the
machine
