7
3. Attach the Track Frame (4) to the Frame (1) with
two M10 x 25mm Patch Screws (48) and two
M10 Split Washers (85).
Tip: Finger tighten a
Patch Screw into the lower hole first, and
then finger tighten a Patch Screw into the
upper hole. Then, tighten both Patch Screws.
Tip: This step may be easier if you raise the
Frame (1) a few inches in the location shown
by the arrow at the right while you attach the
Track Frame (4).
See the inset drawing.
Tighten two Leveling
Feet (36) into the underside of the Track Frame
(4).
85
4
1
48
85
48
3
4. Apply a small amount of the included grease to
the sides of two Wave Washers (88) and two
Thrust Washers (66).
Slide a Weld Spacer (89) onto the left Crank
Arm (83). Next, identify the Left Track Arm (12),
which is marked with an “L.”
Orient the Left Track Arm (12) as shown, and
slide it onto the left Crank Arm (83). Then, slide
a Wave Washer (88) on the end of the left Crank
Arm.
Slide an M8 Small Washer (18) and an Axle Cap
(41) onto an M8 x 19mm Button Screw (56).
Next, slide a Thrust Washer (66) onto the shoul-
der of the Axle Cap. Then, tighten the Button
Screw into the end of the left Crank Arm (83).
Make sure that the Thrust Washer remains
on the shoulder of the Axle Cap, and that the
Wave Washer (88) remains on the end of the
left Crank Arm.
Repeat this step to attach the Right Track
Arm (11)
.
11
4
83
89
88
41
56
12
18
66
Grease
36
4
All manuals and user guides at all-guides.com
