HOT TUBS Algonquin, User Manual

Page: 13 / 40

USER MANUAL
2.
Separate the staves with the pre-drilled holes.
• The Suction stave(s) has a hole cut out about 4 ½ inches up from the croze.
• The Light stave has a hole cut out about 17 inches from the top
of the stave.
• If you have a Bubbler, the Bubbler stave has a hole cut out about
16 1/8 inches from the croze.
• The remainder of the staves that have holes cut out are for your
Jet fittings.
3.
Decide where the Spa Pack will be located and place the Suction stave(s)
on that side of the hot tub.
4.
If you have a Bubbler, the Bubbler stave should be the first stave attached
and span the seam of the floor.
OVAL HOT TUBS
• Suction and Light staves should be placed in the side section of oval hot tubs.
• Always use the “spacer” staves on the side section.
Arrange the staves as shown in the diagram below:
JET
SEAT
LIGHT
SUCTION
BUBBLER JET
SIDE
END
SEAT
13