HOT TUBS Algonquin, User Manual

Page: 18 / 40

CANADIAN HOT TUBS INC.
18
4.
Place the front of the seat support in line with the vertical line you drew up
from the floor, and line up the top of the seat support horizontally so that it
is level with the two marks.
5.
Holding the seat support in position, place a pencil through the centre hole
of the seat support and mark the stave. This is where the “locator” screw
will be inserted.
Note:
The seat support will go into this location after the liner is installed.
6.
Screw in the 1 inch, round-headed screws (provided in kit) halfway into
the mark on the stave. This is the locator screw that marks where the seat
support will be installed after the liner is in the hot tub.
7.
Repeat these instructions for the remaining seat supports.
Footrest Supports
If you have a 5-foot-deep tub, you will also have footrests. Locations for the
footrests may have been marked on your floor in red.
Footrest supports are installed in the same manner as the seat supports (follow
the directions above). The recommended height is 11 inches, but that can be
changed according to individual preferences.
Put seat supports and footrest supports (if applicable) aside for now.
EQUAL
DISTANCE
EQUAL
DISTANCE
SEAT
SUPPORT
SUPPORT
FRONT
SEA
T