HOT TUBS Algonquin, User Manual

Page: 17 / 40

USER MANUAL
17
Instructions
Seat Supports
It is critical that seat supports are positioned correctly. Locations for seat
supports have been marked on the floor for 7-foot-diameter hot tubs.
1.
Place the long seat boards into the hot tub and measure between them so
that they are an equal distance apart.
2.
From the front corner of the seat, draw a line up 17 ½ inches from the floor
and make a mark.
3.
From the back corner of the seat, draw a line up 17 ½ inches from the floor
and make a mark.
Note: This is the recommended seat height for a 4-foot-high tub. If you have a
Bubbler, you must place the seats at this height. If not, you can adjust the seat
height to your preference.
STEP 4 – Marking Seat
and Footrest Supports
CLICK HERE TO WATCH THE SEAT
SUPPORTS, LINER, AND SUCTIONS VIDEO
Important Information
• At least 60 minutes before installing the seat supports, put a
generous amount of silicone on one side of the red silicone washers
and attach them to the back of the seat supports. This will allow
the silicone to form a good seal.
• Do not pre-drill the holes of the seat supports.
Use a screwdriver
to turn the “locator” screw directly into the wood of the hot tub.
Ensure that the lag bolts will go into the stave and not into a joint
between staves.