7
＊Usually an electrical permit and services of a licensed electrician are required.
＊If the power cord is damaged, it must be replaced by a replacement cord available from Manufacturer Parts/Service Centres.
7. WATER SUPPLY AND DRAIN CONNECTIONS
WARNING
Connect to potable water supply only.
＊The connection to the main water supply must be made in accordance with the countries’ current requirements of the Water
Supply or Water Fittings Regulations.
＊Icemaking water must be potable water. Where scaling can be caused by water quality:
-Installation of an external filter or softener is recommended. Contact your local water treatment professional or the
manufacturer’s agency.
-Multistage filtering or deionized filtering may result in the product's failure to work properly. (The reference value of water
conductivity ≥20μs/cm)
＊Water supply pressure should be within 0.07MPa（0.7bar）to 0.55MPa（5.5bar）. If the pressure exceeds 0.55MPa (5.5bar),
use a proper pressure reducing valve. Do NOT throttle back the supply tap.
＊A plumbing permit and services of a licensed plumber may be required in some areas.
＊The icemaker drain is gravity flow, so ensure drain pipe has an adequate pitch or fall.
＊Drain line should not be piped directly to the sewer system. A vertical air gap of minimum of 5cm should be between the end of
the drain pipes from the icemaker and the floor drain.
＊To prevent a backflow into the storage bin, the outlet hose must be laid as shown
.
＊Be sure to use the new hose-sets supplied with the appliance. Do not reuse any old hose-sets
.
1) Attach the free end of inlet hose to the stop valve, noting washer is correctly positioned. Hand
tighten sufficiently to provide leak free joint. It is a wise precaution to have the stop valve within
easy reach.
2) The outlet hose can be cut to appropriate length according to the position of the main drain nozzle.
To prevent condensation, it can be coated some insulation pipe out of drain pipe.
Note: Jointing compounds should be approved and suitable for potable water use.
[SRM-45A] [SRM-60/80/105/125A]
BAD
BAD
Inlet Hose
U
Inlet Hose
Outlet Hose
GOOD
Downgrade
Upgrade
Washer
Stop Valve
Outlet Hose
Inlet Hose
